SeaDoo GTX 4-TEC Instruções de Operação descarregar pdf (Página 83)

81

Disconnect ignition coil connectors.

IMPORTANT: Never cut the locking ties

of ignition coil connectors. This would al-

low mixing the wires between cylinders.

Remove ignition coils.

CAUTION: Ensure there is no dirt in

coil holes prior to removing the spark

plugs. Otherwise, dirt would fall into

cylinder and will damage the internal

components.

Remove spark plugs.

NOTE: After untightening the spark

plugs, a coil may be used to pull the

spark plugs out. Simply bring the coil

down to spark plug and “hook” it to

then extract spark plug.

Spray BOMBARDIER LUBE lubricant

or equivalent, in spark plug holes.

To prevent fuel to be injected and also

to cut the ignition at the engine crank-

ing, proceed as follows.

While engine is stopped, fully depress

throttle lever and HOLD for cranking.

Crank the engine a few turns to distrib-

ute the oil on cylinder wall.

Apply anti-seize lubricant on spark plug

threads then reinstall them.

NOTE: Prior to inserting the ignition coil

to its location, apply some Molykote 111

grease (P/N 413 707 000) around the

seal area that touches the spark plug

hole. After installation, ensure the seal

seats properly with the engine top sur-

face.

Reinstall ignition coils. Reconnect igni-

tion coil connectors.

To reinstall engine cover, push it down-

ward until it snaps.

Wipe up any residual water from the

engine.

Disconnect the garden hose.

NOTE: It is recommended to fog the

engine valves with BOMBARDIER

LUBE lubricant. Contact your autho-

rized Sea-Doo dealer.

Battery

Contact your authorized Sea-Doo dealer.

Engine Cooling System

Antifreeze should be replaced for the

storage period to prevent antifreeze

deterioration.

The antifreeze replacement and a densi-

ty test should be performed by an autho-

rized Sea-Doo dealer.

CAUTION: Improper antifreeze mix-

ture might allow freezing of the liq-

uid in the cooling system if vehicle is

stored in area where freezing point is

reached. This would seriously dam-

age the engine. Failure to replace the

antifreeze for storage may allow its

degradation that could result in poor

cooling when engine will be used.

Bilge Cleaning

The following steps should be per-

formed to provide the watercraft en-

hanced protection.

Clean the bilge with hot water and de-

tergent or with bilge cleaner. Rinse

thoroughly. Lift front end of watercraft

to completely drain bilge.

Anticorrosion Treatment

Wipe off any residual water in the en-

gine compartment.

Spray BOMBARDIER LUBE lubricant

or equivalent over metallic compo-

nents in engine compartment.



WARNING

When disconnecting coil from spark

plug, always disconnect coil from

main harness first. Never check for

engine ignition spark from an open

coil and/or spark plug in the engine

compartment as spark may cause

fuel vapor to ignite.



WARNING

Do not lubricate the safety lanyard

post.

smo2004-001a.book Page 81 Monday, March 31, 2003 12:17 PM

www.SeaDooManuals.net

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 103 104

Comentários a estes Manuais

Sem comentários