SeaDoo GTI LE RFI Especificações descarregar pdf (Página 50)

Hull

Inspect hull for cracks or damage.

Jet Pump Water Intake

Remove weeds, shells, debris or any-

thingelsethatcouldrestricttheflow

of water and damage cooling system

or propulsion unit. Clean as neces-

sary. If any obstruction can not be re-

moved, refer to an authorized Sea-Doo

dealer for servicing.

F18J04Y

21

TYPICAL

1. Water intake

2. Ride plate

Inspect leading edges of the impeller,

if they have nicks or bends perfor-

mance will be greatly reduced.

Bilge

Should water be present in the bilge,

tilt the watercraft to the rear and un-

screw drain plugs to completely emp-

ty the bilge.

Secure bilge drain plugs.



WARNING

Make sure drain plugs are properly

secured prior to launching the wa-

tercraft in water.

Water Flow in Cooling

System (only when

temperature is below

or close to freezing point)

In Northern areas, if watercraft is to

be used when temperature is below

or close to freezing point (0°C(32°F))

or if watercraft was left unused while

temperature was below or close to

freezing point, water may be frozen

in cooling system hoses. This could

cause cooling system overheating. To

ensure it is properly working, do the

following prior to using the watercraft:

– The procedure is to be performed

with watercraft out of water.

– Connect a garden hose to the flush-

ing connector at jet pump.

– Perform the flushing operation as

explained in POST-OPERATION

CARE.

– Ensure water flows out of jet pump.

Otherwise, water is frozen in cool-

ing system and restricts water flow.

Do not operate the watercraft in

this condition.

NOTE: Pay attention that some water

will also flow out of exhaust outlet.

Make sure water is effectively flowing

out of jet pump.

CAUTION:

Operating watercraft

with frozen water in cooling system

might lead to engine components

damage.

NOTE: When water freezes, damage

to engine components should not oc-

cur because of water expansion, but

because it prevents full flow of cool-

ing water.

– Either wait until ice melts or pour

some hot water to cooling sys-

tem components and to engine.

Then, perform the flushing oper-

ation again to make sure water

properly flows out of jet pump. If

you need assistance, refer to an

authorized Sea-Doo dealer.

_____________________

49

www.SeaDooManuals.net

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 120 121

Comentários a estes Manuais

Sem comentários