SeaDoo RX Instruções de Operação descarregar pdf (Página 54)

52

In-Water Cleaning

Rock the watercraft several times while

repeatedly pressing engine start/stop

button for short period without starting

engine. Most of the time, this will re-

move the blockage. Start engine and

make sure water flows out from bleed

outlet and watercraft operates properly.

If system is still blocked, move the craft

out of the water and remove blockage

manually.

If the aforementioned method does not

work, the following can be performed:

– With engine running and before ap-

plying throttle, put shift lever in re-

verse position and vary throttle quick-

ly several times.

– Repeat procedure if necessary.

On-Beach Water Cleaning

Place a cardboard or a carpet beside the

watercraft to prevent scratching when

turning the watercraft for cleaning.

Rotating watercraft in the proper direc-

tion eliminates the possibility of resid-

ual water in the tuned pipe entering the

engine and causing engine damage.

Rotate the watercraft clockwise (seen

from rear) to its right side for cleaning.

Clean the water intake area. If the sys-

tem is still clogged, refer to an autho-

rized Sea-Doo dealer for servicing.

CAUTION: Inspect water intake grate

for damage. Refer to an authorized

Sea-Doo dealer for repair as neces-

sary.

Capsized Watercraft

The watercraft is designed so that it

should not turn over easily. Also two

sponsons mounted on the side of the

hull assist watercraft stability. If it turns

over, it will remain capsized.

CAUTION: Always refer to decal lo-

cated on stern of watercraft.

To return the watercraft upright, en-

sure the engine is off, grab the inlet

grate, step on bumper rail and use your

weight to rotate the watercraft coun-

terclockwise (seen from rear).

Submerged Watercraft

If the watercraft is submerged and en-

gine is water-flooded, it is strongly rec-

ommended that the watercraft be ser-

viced by an authorized Sea-Doo dealer.

Water-Flooded Engine

In the event the engine cannot be ser-

viced within a few hours, remove

spark plug cables and connect them

on the grounding device.

Remove spark plugs and dry them

with a clean and dry cloth.

Cover spark plug holes with a rag.

F06L11Y

Max. 90°



WARNING

Never crank engine with spark

plugs removed unless spark plug

cables are connected to the ground-

ing device.

F06L0DZ

smo2000-003a.book Page 52 Thursday, November 11, 1999 10:44 AM

www.SeaDooManuals.net

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 90 91

Comentários a estes Manuais

Sem comentários