SeaDoo GS Instruções de Operação Página 86
- Página / 109
- Índice
- RESOLUÇÃO DE PROBLEMAS
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
84
TROUBLESHOOTING
All Models Except GTX RFI and GSX RFI
The following chart is provided to help in diagnosing the probable source of sim-
ple troubles. You may be able to solve many of these problems rather quickly, but
others may require the skills of a mechanical technician. In such cases, consult
an authorized Sea-Doo dealer for servicing.
Monitoring Beeper Coded Signals
Engine Will Not Start
CODED SIGNALS POSSIBLE CAUSE REMEDY
2 short beeps (while
installing safety lanyard on
switch).
• Confirms safety lanyard
signal operation.
Engine can be started.
1 long beep (while
installing safety lanyard on
craft switch or when
pressing start/stop button).
• Safety lanyard on switch
for more than 10 minutes
without starting engine.
Remove and reinstall safety lanyard
on switch.
• Bad connection.
Reinstall safety lanyard cap correctly
over switch.
• Wrong safety lanyard.
Use a safety lanyard that has been
programmed for the craft.
• Defective safety lanyard.
Use another programmed safety
lanyard.
• Salt water in safety lanyard
cap.
Clean safety lanyard cap to remove
salt water.
• Improper operation of
MPEM or defective wiring
harness.
Refer to an authorized dealer.
8 short beeps.
• Defective MPEM.
Refer to an authorized dealer.
Continuously beeps.
• Engine overheats.
See ENGINE OVERHEATING.
OTHER OBSERVATION POSSIBLE CAUSE REMEDY
Engine does not turn over.
• Safety lanyard removed.
Install cap over switch.
• Burnt fuse.
Check wiring then replace fuse.
• Discharged battery.
Refer to an authorized dealer.
• Battery connections,
corroded or loose.
Refer to an authorized dealer.
• Water flooded engine.
Refer to Submerged Watercraft in
SPECIAL PROCEDURES.
Engine turns slowly.
• Discharged or weak battery.
Refer to an authorized dealer.
Engine turns normally.
• Close fuel valve.
Turn fuel valve to ON position.
• Fuel tank empty or water-
contaminated.
Refill. Siphon and fill with fresh fuel.
• Fuel filter clogged or
water-contaminated.
Clean, check fuel tank for water.
• Fouled/defective spark
plugs.
Replace.
• Misuse of choke.
Use only with cold engine. Replace
spark plugs.
• Fuel flooded engine.
Replace spark plugs.
Smo9901b.fm Page 84 Friday, September 4, 1998 10:45 AM
www.SeaDooManuals.net
- All rights reserved 2
- Bombardier Inc. 1998 2
- Videocassette 3
- Operator’s Guide 3
- Safety Handbook 3
- Piloting 3
- TABLE OF CONTENTS 4
- FOREWORD 7
- ◆ SAFETY WARNING 8
- LIST OF DISTRIBUTORS 11
- BOMBARDIER LIMITED WARRANTY: 12
- 1999 SEA-DOO 12
- WATERCRAFT 12
- REGISTRATION NUMBER LOCATION 14
- SP Series 15
- GS Series 16
- XP Series 17
- GTS Series 18
- GT Series 19
- TO CLOSE / POUR FERMER 20
- Emission Control Information 21
- WATERCRAFT IDENTIFICATION 22
- 787 Engine 23
- 947 Engine 23
- COMPONENTS IDENTIFICATION 24
- XP Limited 26
- GTS Model 27
- COMPONENTS FUNCTIONS 30
- 5) Fuel Valve 31
- 6) Safety Lanyard Switch 31
- 7) Docking Eyelets 32
- 8) Seat Latch 32
- 9) Rear Grab Handle 33
- 10) Boarding Pads 33
- 11) Cooling System Bleed 33
- Outlet(s) 33
- 12) Jet Pump Nozzle 34
- 13) Air Intake Opening 34
- 14) Bilge Drain Plugs 34
- 15) Bow and Stern Eyelets 34
- 1. Stern eyelet 35
- 1. VTS button 35
- 1. Bow up 35
- 2. Bow down 35
- 22) Boarding Platform 36
- 23) Seat Strap 36
- 24) Monitoring Beeper 36
- 25) Fuel Gauge/Low Oil 36
- Warning Light 36
- 26) Speedometer 37
- 27) Engine Compartment 37
- 28) Oil Injection Tank Cap 37
- GTI, GTX Limited and GTX RFI 38
- GS, GSX Limited and GSX RFI 38
- 45) Storage Compartment 40
- Cover Safety lock 40
- 46) Handlebar Adjustment 40
- 47) Cargo Cleats 40
- 48) Boarding Step 41
- 49) Info Center Gauge 41
- FUEL AND LUBRICATION 43
- Oil Injection System 44
- BREAK-IN PERIOD 45
- PRE-OPERATION CHECKS 47
- Safety Lanyard and Engine 49
- Start/Stop Button 49
- Clothing 49
- OPERATING INSTRUCTIONS 50
- 2. Bow up 52
- 3. Nozzle up 52
- 3. Nozzle down 53
- Boarding from a Dock or 54
- Starting the Engine 54
- GSX RFI, GTX RFI Models 55
- All Models 55
- Boarding in Deep Water 56
- Rough/Choppy Water 57
- Operation 57
- Crossing Waves 57
- Stopping/Docking 57
- Beaching 58
- Shutting Off the Engine 58
- POST-OPERATION CARE 59
- All Models Except SPX and GTS 60
- SPX and GTS Models 61
- Anticorrosion Treatment 62
- SPECIAL PROCEDURES 63
- Capsized Watercraft 64
- Submerged Watercraft 65
- Towing the Watercraft in 65
- Low-charge Battery 66
- Condition 66
- All Models Except GTX RFI and 67
- GTX RFI and GSX RFI Models 67
- MAINTENANCE 68
- All Models Except XP Limited 69
- Periodic Inspection 70
- Periodic Inspection Chart 71
- 1. Must move freely 72
- Vacuum Bailer Pick-Ups 73
- Water Tank Trap Drains 73
- SPX Model 74
- GSX RFI and GTX RFI Models 75
- General Inspection and 78
- TRANSPORTATION, STORAGE 79
- AND PRE-SEASON PREPARATION 79
- Pre-Season Preparation 84
- TROUBLESHOOTING 86
- SPECIFICATIONS 91
- N.A.: Not Applicable 93
- (47.7 in 101
- SI* METRIC INFORMATION 103
- OTHER PUBLICATIONS AVAILABLE 105
- DEALER IMPRINT AREA 106
- CHANGE OF ADDRESS 107
Manuais e produtos relacionados com Motor SeaDoo GS
Motor SeaDoo GTI LE RFI Especificações
(121 páginas)
(121 páginas)
Motor SeaDoo GSX Limited Manual do Utilizador
(11 páginas)
(11 páginas)
Motor SeaDoo XP DI Instruções de Operação
(24 páginas)
(24 páginas)
Motor SeaDoo SP Manual de Serviço
(316 páginas)
(316 páginas)
Motor SeaDoo GS Instruções de Operação
(100 páginas)
(100 páginas)
Motor SeaDoo GSX Manual de Serviço
(56 páginas)
(56 páginas)
© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.066 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais