SeaDoo SP Manual de Serviço descarregar pdf (Página 145)

Section 07 LUBRIFICATION SYSTEM

Sub-Section 02 (OIL INJECTION PUMP)

07-02-6

Bench Test

The oil pump must be removed out of watercraft.

Connect a hose filled with injection oil to main line

fitting. Insert other hose end in an injection oil

container. Using a counterclockwise (reverse po-

sition) rotating drill rotate pump shaft. Oil must

drip from fittings in parts of rotary valve cover

while holding lever in a fully open position.

TYPICAL

1. Supply oil line to an oil container

2. Hold lever in fully open position

3. Counterclockwise (reverse) rotating drill

4. Oil must drip here

For an accurate test, each port should be checked

separately to ensure equal delivery on both ports.

To obtain a precise result of the oil pump delivery

rate, rotate it counterclockwise at 1500 RPM for a

total time of 30 seconds.

NOTE : To ensure accuracy of test, oil lines

should be completely filled before starting

test.

Compare the results with the chart below. If oil

pump is out of specification, replace it.

NOTE : Test can also be done at 3000 RPM.

Double quantities in chart.

F01G02A

Engine 587 717 787

Oil Pump

Flow Rate at

1500 RPM

(30 seconds)

0.83 - 1.00 mL

(each port)

1.24 - 1.51 mL

(each port)

0.71 - 0.87ml

(each port)

www.SeaDooManuals.net

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 315 316

Sem comentários

SeaDoo SP Manual de Serviço Página 145