SeaDoo SP Manual de Serviço descarregar pdf (Página 210)

Section 09 PROPULSION SYSTEM

Sub-Section 01 (JET PUMP)

09-01-11

21, Seal

To remove seal, proceed as follows :

CAUTION : It is not recommended to

push seal out with a punch. Housing and /

or bearing(s) could be damaged.

Seal should be removed using the following sug-

gested tool.

Seal puller, Snap-on no. S6129.

1. Pulling seal out of housing

Or, use a Snap-on hammer puller including :

Handle CJ93-1

Hammer CJ125-6

Claws CJ93-4

Close puller claws so that they can be inserted be-

tween seal and bearing. Holding claws, turn puller

shaft clockwise so that claws open and tighten

against seal.

Slide puller sleeve outwards and gently tap puller

end. Work with small strikes otherwise claws will

slip out. As soon as seal begins to slide out, re-

tighten claws to maintain contact with seal. Con-

tinue pulling until seal is out.

1. Pulling seal out of housing

NOTE : If bearings and seal need to be re-

placed the special driver described further

on in bearing removal can be used. Simply insert

driver from the rear and press parts towards the

front.

1. Same tool for bearing removal

2. Removing seal and bearings out from rear

F01J0XAF01J0XA

F01J0YA

F01J0ZA

F01J10A

F01J12A

www.SeaDooManuals.net

1 2 ... 205 206 207 208 209 210 211 212 213 214 215 ... 315 316

Sem comentários

SeaDoo SP Manual de Serviço Página 210