SeaDoo SP Manual de Serviço descarregar pdf (Página 188)

Section 08 ELECTRICAL SYSTEM

Sub-Section 04 (STARTING SYSTEM)

08-04-7

Step Retaining brush holder with a screwdriver

Step Align here

Align end frame notch with brush holder notch /

yoke protrusion.

CAUTION : Make sure end frame fits per-

fectly on yoke.

STARTER INSTALLATION

Installation is essentially the reverse of removal

procedure. However, pay particular attention to

the following.

Make sure that starter and engine mating surfac-

es are free of debris. Serious trouble may arise if

starter is not properly aligned.

13,14, Screw

Torque starter screws to 22 N•m (16 lbf•ft).

15, Nut

Connect the RED battery cable to the starter and

torque nut to 6 N•m (53 lbf•in). Apply dielectric

grease on terminal and nut.

16,17, Screw and Teeth Washer

Apply Loctite 271 (red) on screw.

Connect BLACK cable to starter using flat washer,

teeth washer and screw. Torque screw to 22 N•m

(16 lbf•ft). Apply dielectric grease on terminal and

screw.

Step Torque nut to 6 N•m (53 lbf•in)

Step Apply Loctite 271 on screw

Step orque screw to 22 N•m (16 lbf•ft)

Step Apply dielectric grease

WARNING : Always connect RED positive

cable first then BLACK negative cable last.

Whenever connecting the RED positive cable

to the starter motor make sure the battery ca-

bles are disconnected to prevent electric

shock.

F01H0UA

F01HiJC

1 4

;

www.SeaDooManuals.net

1 2 ... 183 184 185 186 187 188 189 190 191 192 193 ... 315 316

Comentários a estes Manuais

Sem comentários

SeaDoo SP Manual de Serviço Página 188

Comentários a estes Manuais

Manuais e produtos relacionados com Motor SeaDoo SP