SeaDoo SP Manual de Serviço descarregar pdf (Página 178)

Section 08 ELECTRICAL SYSTEM

Sub-Section 03 (CHARGING SYSTEM)

08-03-5

This chart will be useful to find the correct read-

ing.

Battery Storage

Disconnect and remove battery from watercraft.

Check electrolyte level in each cell, add distilled

water up to upper level line.

CAUTION : Do not overfill.

The battery must always be stored in fully

charged condition. If required, charge until specif-

ic gravity of 1.260 is obtained.

CAUTION : Battery electrolyte tempera-

ture must not exceed 50°C (122°F). The

casing should not feel hot.

Clean battery terminals and cable connections us-

ing a wire brush. Apply a light coat of dielectric

grease on terminals.

Clean battery casing and caps using a solution of

baking soda and water.

CAUTION : Do not allow cleaning solution

to enter battery.

Rinse battery with clear water and dry well using

a clean cloth.

Store battery on a wooden shelf in a cool dry

place. Such conditions reduce self-discharging

and keep fluid evaporation to a minimum. Keep

battery away from dew, high moisture and direct

sunlight.

During the storage period, recheck electrolyte lev-

el and specific gravity readings at least every

month. If necessary, keep the battery at its upper

level line and near full charge as possible (trickle

charge).

Activation of a New Battery

WARNING : Never charge or boost bat-

tery while installed in watercraft.

A new battery is factory fresh dry charged. For

storage purposes, it is fitted with a temporary

sealing tube.

CAUTION : Do not remove the sealing

tube or loosen battery caps unless activa-

tion is desired.

In case of accidental premature removal of caps

or sealing tube, battery should be given a full

charge.

Perform the following operations anytime a new

battery is to be installed.

1. Remove the sealing tube from the vent elbow.

WARNING : Failure to remove the sealing

tub could result in an explosion.

2. Remove caps and fill battery to UPPER LEVEL

line with electrolyte (specific gravity : 1.260 at

21°C (70°F)).

NOTE : This battery may fill slower than oth-

ers due to the anti-spill check ball design.

1. Sealing tube removed

2. Battery electrolyte

3. Upper level line

ELECTROLYTE

TEMPERATURE

OPERATION TO PERFORM

°C °F

100

.012

.008

.004

Add

to the reading

21 70 correct reading

–1

004

.008

012

016

Subtract

from the

reading

EXAMPLE NO. 1

Temperature above 21°C (70°F) :

Hydrometer reading : 1.250

Electrolyte temperature : –1°C (30°F)

Subtract .016 Sp. Gr.

Corrected Sp. Gr. is 1.234

EXAMPLE NO. 2

Temperature above 21°C (70°F) :

Hydrometer reading : 1.235

Electrolyte temperature : 38°C (100°F)

Add .012 Sp. Gr.

Corrected Sp. Gr. is 1.247

;

A17E0FB

www.SeaDooManuals.net

1 2 ... 173 174 175 176 177 178 179 180 181 182 183 ... 315 316

Comentários a estes Manuais

Sem comentários

SeaDoo SP Manual de Serviço Página 178

Comentários a estes Manuais

Manuais e produtos relacionados com Motor SeaDoo SP